TeslaMeter 2000

The Smart Magnetic Sensor

SMS 210 and probe

Tel-Atomic's new pocket size TeslaMeter 2000 is unique for the features offered. The Sensor will measure axial or transverse magnetic fields up to 2000 mT, and can be set for Auto range. However, if one of the 3 manual ranges is selected, an analog output of 2 volts for FSD of each range is possible, making it easy to use with a computer interface.

With the 4½ Digit LCD readout you can use the sensor as a stand-alone magnetic field meter. In addition, the sensor connects to the USB port of your computer, allowing you to take data with the included software.

An EEPROM inside the probe has been programmed for temperature compensation of non-linearity error. Following a patented method, the unit removes temperature effects of magnetic sensitivity, resistive residual voltage and also all magneto resistive effects . If necessary, the unit can be re-calibrated easily with the help of the Zero-Gauss Chamber.

TeslaMeter 2000 Software

The TeslaMeter 2000 Software automatically collects data from the TeslaMeter 2000. The software automatically recognizes the range selected. An autoscaling feature on both axes means you don't have to worry about which range to select. Data is taken at a constant rate of 1 Hz for up to 2 hours. A manual mode is also provided. This allows you to plot magnetic field vs. position. Data is taken each time a key is pressed. You can then move the probe, press the key and get a reading at that position. Autoscaling of both axes is also provided in this mode. The software is extremely easy to use.

The TeslaMeter 2000 comes with complete operating instructions, a transverse probe, and axial probe, the zero Gauss chamber, and software.

TEL-SMS111UC $1015.00
TEL-SMS111 manual download

Measurement Ranges:
19.99 mT, 1µT resolution
199.99 mT, 10µT resolution
1999.9 mT, 0.1mT resolution
Measured value mode:
Constant Magnetic Field [mT]
Alternating Magnetic Field, up to 500 Hz RMS [mT]
Magnetic Field Sensor: Hall Effect GaAs type sensor
Measurement Probes: Axial and Transverse, 12.5 mm long, 100 cm cable with 9 pin "D" type male connector
DC Range Accuracy: 0.05% full scale reading
AC Range Accuracy: 0.2% full scale reading
Resolution: 0.001mT
Range selection: Manual, Auto
Digital data format: ASCII data + XX.XX mT "CR" "LF"; +XXX.X mT "CR" "LF"; +XXXX mT "CR" "LF"
Analog output: 2V for FSD
Measuring utilities:
Zero the hall sensor with the "Zero Gauss Chamber".
Set offset readout for the current field.
Non-Volatile memory for caching the "last used" measurement range and mode.
User buttons:
Power: on / off
Measurement mode: AC/DC
Measurement range: 2000mT, 200mT, 20mT, AUTO
Zeroing: readout offset / sensor zero
Power Off: Manual or Auto after 10 min. Auto off disabled when attached to computer
Power On: Manual
Total Weight: 200g (including batteries)
Dimensions (HxWxD): 130mm x 75mm x 26mm
Display: 4 1/2 digit LCD
Readout frequency: 4Hz
Supply: 3 x R3 (AAA) type cells (included)
External Power Supply: USB socket